Install The Ailerons; Additional Items Required; Tools And Supplies Needed - Seagull Models EDGE 540 V3 Assembly Manual

KIT CONTENTS
SEA383 Edge 540 V3, 77.5" wingspan
35-40cc
1. Fuselage
2. Wing set (2)
3. Tail set (2)
4. Cowling
5. Wing tube
6. Landing gear
7. Fuel tank
8. Tail wheel
9. Pilot
10. Spinner

ADDITIONAL ITEMS REQUIRED

�
35-40cc gasoline engine.
�
Computer radio 6 channel with 6
servos.
�
Glow plug to suit engine.
�
Propeller to suit engine 20x8-21x10.
�
Protective foam rubber for radio
system.
TOOLS & SUPPLIES NEEDED
hin cyanoacrylate glue.
Medium cyanoacrylate glue.
30 minute epoxy.
5 minute epoxy.
Hand or electric drill.
Assorted drill bits.
Modelling knife.
Straight edge ruler.
2mm ball driver.
Phillips head screwdriver.
220 grit sandpaper.
90° square or builder's triangle.
Wire cutters.
Masking tape & T-pins.
hread-lock.
Paper towels.

INSTALL THE AILERONS

Please see pictures below.
1.
2.
Remove the ailerons from the wing and
remove the hinges.
Use a small piece of rough sandpaper to
scuf the hinges for better epoxy adhesion.
Do this to all aileron hinges.
3.
Apply epoxy to each hinge where it will
be inserted into the ailerons. Tip: Apply
some petroleum jelly to the metal pin
hinge area to keep epoxy from interfering
with smooth operation of hinge.
Epoxy
3