Installing The Aileron - Flap Servos; Installing The Spinner - Seagull Models Piper Comanche MS:142 Assembly Manual

4) Locate the plywood battery tray to the
fuselage. Tighten the screws using machine
screws M3x15mm to secure the tray in position.
Battery.
5) Attach the speed control to the side of the
motor box using two-sided tape and tie wraps.
Connect the appropriate leads from the speed
control to the motor. Make sure the leads will
not interfere with the operation of the motor.
Speed control.

INSTALLING THE SPINNER.

Install the spinner backplate, propeller and
spinner cone.
www.seagullmodels.com
Battery.
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of
the mount allow the servo lead to pass through.
1) Using a small weight (
works well
the wing as indicated.
The propeller should not touch any part
of the spinner cone. If it does, use a

INSTALLING THE AILERON - FLAP SERVOS.

Servos.
Because the size of servos differ, you
) and string, feed the string through
Small weight.
Small weight.
Thread.
Weighted fuel pick-up
String.
17