Additional Items Required; Tools And Supplies Needed - Seagull Models SEA276 Assembly Manual

KIT CONTENTS.
SEA276 P-51D MUSTANG
1. Fuselage
2. Wing set
3. Tail set
4. Canopy
5. Cowling
6. Aluminium tube
7. Pilot

ADDITIONAL ITEMS REQUIRED.

�
10-15cc gasoline engine.
�
Computer radio with 7 servos.
�
Glow plug to suit engine.
�
Propeller to suit engine.
�
Protective foam rubber for radio
system.
TOOLS & SUPPLIES NEEDED.
hin cyanoacrylate glue.
Medium cyanoacrylate glue.
30 minute epoxy.
5 minute epoxy.
Hand or electric drill.
Assorted drill bits.
Modelling knife.
Straight edge ruler.
2mm ball driver.
Phillips head screwdriver.
220 grit sandpaper.
90° square or builder's triangle.
Wire cutters.
Masking tape & T-pins.
hread-lock.
Paper towels.
HINGING THE FLAP.
Note : he control surfaces, including the ai-
lerons, elevators, and rudder, are prehinged
with hinges installed, but the hinges are not
glued in place. It is imperative that you prop-
erly adhere the hinges in place per the steps
that follow using a high-quality thin C/A glue.
1) Carefully remove the lap from one of the
wing panels. Note the position of the hinges.
2) Remove each hinge from the wing panel
and lap and place a T-pin in the center of
each hinge. Slide each hinge into the wing
panel until the T-pin is snug against the wing
panel. his will help ensure an equal amount
of hinge is on either side of the hinge line
when the lap is mounted to the wing.
.
3) Slide the wing panel on the lap until there
is only a slight gap. he hinge is now centered
on the wing panel and lap. Remove the T-
pins and snug the lap against the wing panel.
A gap of 1/64" or less should be maintained
between the wing panel and lap.
Hinge.
3