General Cleaning; General Care - LifeSpan Chief Owner's Manual

applying lubricant to your treadmill.
• Turn off the treadmill with the on/off switch, then unplug the power cord at the wall outlet.
• Loosen both the rear roller bolts. (For best results, place two removable marks on both sides
of the frame and note roller position).Once the belt is loosened, take the bottle of lubricant and
apply it to the entire top surface of the running deck. Tighten both rear roller bolts (matching up
the marks for proper position) to original position. After you have applied lubricant, plug in the
power cord, key, start the treadmill and walk on the belt for two minutes to spread the lubricant.
• Lubricate the air shocks with Teflon based spray.
EVERY 2 YEARS
It is necessary that you change your treadmill motor brushes once every 2 years to avoid
damaging your motor. If you fail to change the brushes this may cause the motor to burn out,
voiding any warranty.
PLEASE NOTE: TREADMILL MOTOR BRUSHES NEED TO BE CHANGED EVERY 2
YEARS OTHERWISE MOTOR WARRANTY WILL BE VOID.REFER TO MANUAL
SERVICING: IF YOU FAIL TO COMPLY WITH LIFESPAN'S
SERVICING STEPS ABOVE, YOU MAY VOID YOUR WARRANTY. IF YOU REQUIRE A
SKILLED LIFESPAN REPRESENTATIVE TO UNDERTAKE ONE OF THE STEPS ABOVE,
PLEASE EMAIL US AT lifespanfitness@hotmail.com.

2 General Cleaning


Use a soft, damp cloth to wipe the edge
frame. A mild soap and water solution along with
textured belt. This task should be done onc

On a monthly basis, vacuum under neath your treadmill to prevent
you should remove the black motor shield

3 General Care

Check parts for wear before use.
CHIEF
of the belt and the area between the belt edge and
a nylon scrub brush will clean the top of the
e a month. Allow to dry before using.
and vacuum out dirt that may accumulate.
- 22 -
MAINTENANCE AND
dust build up. Once a year,