General Cleaning - LifeSpan PERFORMER PLUS User Manual

• Return the treadmill to its previous position.
EVERY MONTH -IMPORTANT!
• Inspect all assembly bolts of the machine for proper tightness.
• Turn off the treadmill with the on/off switch, then unplug the power cord and wait 60 seconds.
• Remove the motor cover. Wait until ALL LED lights turn off.
• Clean the motor and lower board area to eliminate any lint or dust particles that may have accumulated.
Failure to do so may result in premature failure of key electrical components.
EVERY 6 MONTHS
It may be necessary to lubricate your treadmill running deck at least once every six months to maintain optimal
performance of your treadmill (refer to section 4.4 for information). Only use lubricant provided by Lifespan Fitness!
Please contact Lifespan Fitness with questions about applying lubricant to your treadmill.
• Turn off the treadmill with the on/off switch, then unplug the power cord at the wall outlet.
• Loosen both the rear roller bolts. (For best results, place two removable marks on both sides of the frame and
note roller position).Once the belt is loosened, take the bottle of lubricant and apply it to the entire top surface of
the running deck. Tighten both rear roller bolts (matching up the marks for proper position) to original position.
After you have applied lubricant, plug in the power cord, key, start the treadmill and walk on the belt for two
minutes to spread the lubricant.
• Lubricate the air shocks with Teflon based spray.
EVERY 2 YEARS
It is necessary that you change your treadmill motor brushes once every 2 years to avoid damaging your motor. If
you fail to change the brushes this may cause the motor to burn out, voiding any warranty.
PLEASE NOTE: TREADMILL MOTOR BRUSHES NEED TO BE CHANGED EVERY 2 YEARS
OTHERWISE MOTOR WARRANTY WILL BE VOID.REFER TO MANUAL
SERVICING: IF YOU FAIL TO COMPLY WITH LIFESPAN'S MAINTENANCE AND SERVICING STEPS ABOVE,
YOU MAY VOID YOUR WARRANTY. IF YOU REQUIRE A SKILLED LIFESPAN REPRESENTATIVE TO
UNDERTAKE ONE OF THE STEPS ABOVE, PLEASE EMAIL US AT lifespanfitness@hotmail.com.

5.2 General Cleaning

 Use a soft, damp cloth to wipe the edge of the belt and the area between the belt edge and
frame. A mild soap and water solution along with a nylon scrub brush will clean the top of
the textured belt. This task should be done once a month. Allow to dry before using.
 On a monthly basis, vacuum underneath your treadmill to prevent dust build up. Once a
LIFESPAN PERFORMER PLUS 20