LifeSpan Chief Owner's Manual page 25

belts to drift near one side while the belt is running with no one on it. After a few minutes of use, the
belt should have a tendency to centre itself. If during use, the belt continues to move toward one
side, adjustments are necessary. The procedures are as below:
▲ First set speed at approximately 3.5km/h.
▲ Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm Allen Key,
until the belt is centered itself; If belt shifts to left, tighten the left bolt and loosen the right bolt by
using 6mm Allen Key, until the belt is centered. When adjusting the belt using the 6 mm Allen Key, it
is important to adjust the belt in half turn increments. Over adjusting the belt can cause damage to
the mat.
If the belts has drifted to the RIGHT
CHIEF
If the belts has drifted to the LEFT
- 25 -