Table of Contents
Advertisement
EVERY MONTH -IMPORTANT!
• Inspect all assembly bolts of the machine for proper tightness.
• Turn off the treadmill with the on/off switch, then unplug the power cord and wait 60 seconds.
• Remove the motor cover. Wait until ALL LED lights turn off.
• Clean the motor and lower board area to eliminate any lint or dust particles that may have
accumulated.
Failure to do so may result in premature failure of key electrical components.
EVERY 6 MONTHS
It may be necessary to lubricate your treadmill running deck at least once every six months to
maintain optimal performance of your treadmill (refer to section 4.4 for information). Please
contact Lifespan Fitness with questions about applying lubricant to your treadmill.
• Turn off the treadmill with the on/off switch, then unplug the power cord at the wall outlet.
• Loosen both side of rear roller bolts. (For best results, place two removable marks on both sides
of the frame and note roller position).Once the belt is loosen, take the bottle of lubricant and
apply it to the entire top surface of the running deck. Tighten both rear roller bolts (matching up
the marks for proper position) to original position. After you have applied lubricant, plug in the
power cord, key, start the treadmill and walk on the belt for two minutes to spread the lubricant.
• Lubricate the air shocks with Teflon based spray.
EVERY 2 YEARS
It is necessary that you change your treadmill motor brushes once every 2 years to avoid
damaging your motor. If you fail to change the brushes this may cause the motor to burn out,
voiding any warranty.
PLEASE NOTE: TREADMILL MOTOR BRUSHES NEED TO BE CHANGED EVERY 2
YEARS OTHERWISE MOTOR WARRANTY WILL BE VOID.REFER TO MANUAL
SERVICING:
IF YOU FAIL TO COMPLY WITH LIFESPAN'S
SERVICING STEPS ABOVE, YOU MAY VOID YOUR WARRANTY. IF YOU REQUIRE A
SKILLED LIFESPAN REPRESENTATIVE TO UNDERTAKE ONE OF THE STEPS ABOVE,
PLEASE EMAIL US AT lifespanfitness@hotmail.com.
2 General Cleaning
Use a soft, damp cloth to wipe the edge of the belt and the area between the belt edge and
frame. A mild soap and water solution along with a nylon scrub brush will clean the top of
the textured belt. This task should be done once a month. Allow to dry before using.
On a monthly basis, vacuum underneath your treadmill to prevent dust build up. Once a
year, you should remove the black motor shield and vacuum out dirt that may accumulate.
3 General Care
Check parts for wear before use.
Pay particular attention to the fixing knobs and make sure they are tight.
Always replace the mat if worn and any other defective parts.
8
MAINTENANCE AND
Advertisement
Table of Contents
