Table of Contents
Advertisement
available for the cameras supporting iris control function.
4) FOCUS
5) Preset: the camera can set the position of the preference area.
6) Tour: The camera automatically runs between/among the preset points that you selected.
7) Scan: The camera moves to the preset points in the specified sequence. If multiple presets are
specified, the PTZ camera will automatically move to all of the preset points sequentially. (some
PTZ model may not support this function)
8) Pattern: Makes the PTZ camera remember and follow the past route. (some PTZ model may not
support this function)
9) <Setup-Preset>
10) Delete Preset>
Before entering the PTZ device control mode, set the Values of the PTZ device in the < PTZ Control
Cam #> menu.
PRESET SETTING
A preset is a set of specific target points of a PTZ camera and up to 128 presets per camera can be
stored.
1) In PTZ Control mode, use the direction buttons to adjust the camera to desired direction. Firstly
set the preset number and then adjust the camera to the desired direction.
2) And then, select the <Setup-Preset> key
A virtual keyboard will appear to input the desired name.
-
3) Save: You can save the preset settings by click OK button in the virtual keyboard.
4) Preset Call: when the users select the stored location number, the camera will move to the
selected location.
5) Delete>
: It will delete the selected preset information.
Depending on the IP cameras, the Tour, Scan and Pattern setting may not be available in the NVR.
: Enables you to adjust the focus manually.
: You can change the preset numeric value and name, and Tour setting.
: You can delete the preset and tour position setting.
.
97
Advertisement
Table of Contents
