Table of Contents
Advertisement
Shuttle
Jog
Keyboard Setup- For USB
To setup the keyboard controllers, the user needs to setup the network, passwords and perform
special tasks such as Uploading and Downloading programmed data from the dome cameras. To
enter the Keyboard menu, press and hold CTRL and press MENU expressed as CTRL + MENU in the
manual. You will see the following menu.
Please select 2. Network from the Main Menu
Network
1. Baud Rate
2. Com Ports
3. USB
4. MUX Config
5. Set Slave KBD
Save and exit
Then select 3. USB and then select the USB to ON position
USB
Menu
Status
ON
USB
OFF
The Shuttle Ring operates in the Playback mode only.
Turning the ring clockwise plays video forward. Turning
the ring counterclockwise plays video backward.
The Jog Dial operates only when playback video has
been paused. By turning the jog dial clockwise, you can
play video forward image-by-image.
Enters the Baud Rate setup submenu.
Enters the Communications Ports setup submenu.
USB Mode Enable/Disable
Set the multiplexer configuration.
Select to use the slave keyboard or not.
Save the changed settings and return to the previous menu
Client Keyboard : Only USB Port(The other ports and slave keyboards
are not supported)
General Keyboard : Dome1/Dome2/RS232(The USB port is not
supported)
Configuration
138
Advertisement
Table of Contents
