Table of Contents
Advertisement
is occurred, the NVR system will trigger the event.
3.3.3. Alarm Schedule
You can set the conditions and operating hours for scheduled alarms.
IF the user wants to set the Alarm recording, the user should first set all the Alarm settings
under the "Alarm Schedule" menu.
Event sync. When the alarm is triggered, Beep sound is activated only for the period of the setting
dwell time (continuous, 5sec, 20sec ~ 3 hours).
Alarm Schedule:
1) ON: Marked in Blue, it will generate alarm out when the event occurs on scheduled time.
2) OFF: Marked in Black, no alarm out is generated even if an event occurs.
3) Event Sync: Marked in Green, it generates an alarm out and beep sound when an event occurs.
4) Channel Setup: Only selected channel will generate the Alarm out. If the user does not select
certain channel, and when the event occurs in that channel, the NVR will not generate the Alarm
Out for that channel. However, event recording and other beep will not be affected from this
The alarm out port numbers of terminal block which is on the rear panel.
When Beep (Event Sync) is selected, and alarm schedule mode is set as
47
Advertisement
Table of Contents
