1) By clicking POS USE, your NVR and POS will be connected. If you change settings for the device
and press <OK> while the <POS USE> is not checked, the changes for POS will not be saved.
2) POS COMMUNICATION SETUP WITH NVR: This allows communication setups for the POS
device and NVR. To set up communication, go to Device Menu under System Controller and
select RS-232 to change settings.
*See Appendix POS configuration setup*
3.3.7. Video Analysis
1) Mode ON: Video Analysis will be activated. Mode OFF: Video Analysis will be deactivated.
2) Protocol: Select device/Protocol. (Currently only have ATV / Hitron).
[Video Analysis Setting]
50