Table of Contents
Advertisement
2.2.2. Using a Dynamic IP Address
You can use a router with your Dynamic IP broadband modem. In this case, you should set the
configuration of a router properly for network connection between NVR and Net/Web Viewer.
Please follow the instructions in next section to configure your router correctly.
If your Broadband Modem does not support internal loop back (port forwarding) function and you
want to monitor NVR using a PC located in same Intranet, you should use Direct IP instead of
DVRNS in the connection menu of NetViewer. If your PC is located outside of Intranet, you can
use both DVRNS and Direct IP to connect to NVR even though your Broadband Modem has
limited features.
2.2.3. Router Configuration
If your NVR is connected to the network through a router, you should configure router properly.
There are 3 steps as follows.
1. WAN Setting
2.2.3.1. WAN Setting
Home/Office Network
2. DHCP Setting
3. Virtual Server Setting
Internet
When you connect to your Router, you
can find menu for WAN setting. Please
confirm the WAN setting. If you are using
DSL service, you should select PPPoE,
and you will be directed to a sub-menu to
type in DSL user name and password.
15
Advertisement
Table of Contents
