Cycle Count Retrieval; Temperature & Voltage Display Mode; Show Off/Showroom Wash Mode - Fisher & Paykel DD603 User Manual

Cycle Count Retrieval

(not available on integrated models)
To display the cycle count on the LCD screen, pause the DishDrawer while
running a Continuous Cycle. The two bytes of the cycle count will be
displayed alternately, in syncronisation with the changing backlight.
The Low byte is displayed when the backlight is off.
The High byte is displayed when the backlight is on.
To calculate the Total DishDrawer cycle count use the formula below.
Cycle_Count = (200 x High_byte) + Low_byte.
Eg. Low_byte = 156
High_byte = 2
Cycle_count = (200 x 2) + 156 = 556.
Temperature & Voltage Display Mode
(Not available on integrated models)
During a wash cycle, the current water temperature or the power supply rail
voltage of the controller can be displayed on the LCD instead of the time
remaining. To enter temperature/voltage display mode, start a wash cycle as
normal. Initiate a keylock by pushing and holding the KEYLOCK button for 4
seconds
Once in keylock mode, push and hold START/PAUSE for 8 seconds to enter
temperature display mode. The display now alternates between a °C symbol
and the water temperature. Pressing the START/PAUSE again changes the
display to alternate between an °E symbol and the power supply rail voltage
of the controller.
To cancel temperature/voltage display mode, press the POWER button.

Show Off/Showroom Wash Mode

This mode initiates a shop show off display and wash operation
demonstration.
With the DishDrawer powered up and turned on, the show off mode is entered
by holding the ECO and POWER buttons simultaneously for 5 seconds.
Ensure that ECO is pushed first.
12