Continuous Cycle Test Mode; Fast Test Cycle - Fisher & Paykel DD603 User Manual

Fast Test Cycle

This level runs a 5 minute fast test cycle.
Press POWER to skip Fast Test Cycle and advance to the next level.
Press START/PAUSE to enter Fast Test cycle.
Once Fast Test Cycle is selected the DishDrawer goes into standby mode
and 5 minutes will be showing on the display. The test cycle is started by
pushing START/PAUSE and the following components are run during the 5
minute cycle that follows:- Lid motors, fill valve, wash motor, element, drain
motor.
Press POWER to Exit at any time.

Continuous Cycle Test Mode

In this level the DishDrawer can be run continuously in any wash cycle. Once
the cycle has finished, the DishDrawer automatically restarts the same wash
cycle.
Press POWER to skip Continuous Cycle. As this is the last level, doing this
will exit diagnostics.
Press START/PAUSE to enter Continuous Cycle.
Once selected, the LCD backlight flashes on and off to indicate the
DishDrawer is in continuous cycle and the cycle starts straight away (for
integrated models the LED above the start/pause button will be orange
instead of green to indicate the DishDrawer is running in continuous cycle). It
will run the last cycle that had been selected prior to going into diagnostics
mode.
If it is desired to run a different cycle, exit diagnostics, turn the DishDrawer on
as normal and select the cycle required. Then turn the DishDrawer off again,
re-enter diagnostics and restart the Continuous Cycle as above.
Press POWER to Exit at any time.
11