Paper Tray Assy #1 (Dx Paper Tray Assy #1*) - Brother DCP6690CW Service Manual

6.1.17 Paper Tray ASSY #1 (DX Paper Tray ASSY #1*)

(1) Pull the four lock arms on the rear of the paper tray #1 (DX paper tray #1*) outwards and
release the four latches of the bank ASSY. Then pull the bank ASSY up and out of the
paper tray #1 (DX paper tray #1*).
(2) If the base pad(s) or the tray flap pads* need to be replaced, peel them off the bottom of the
paper tray #1 (DX paper tray #1*).
Note: Once removed, the base pad(s) and the tray flap pads* will become unusable and
new pads will have to be put back in.
Latch
Lock arm
(Rear)
Paper tray #1
(DX paper tray #1*)
Bank ASSY
Depressed
section
Paper tray #1
For paper tray ASSY #1
Assembling Notes
• When attaching a new base pad(s) or tray flap pads* to the paper tray #1 (DX paper tray #1*),
align the edge of the pad(s) with the front or rear edge of the depressed section on the paper
tray #1 (DX paper tray #1*) respectively, as shown above.
• When mounting the bank ASSY, first insert the four pawls into the openings in the paper tray
#1 (DX paper tray #1*) and then press the inside of the bank ASSY so that the latches snap
into place.
Unlatching the bank ASSY
Pawls
Base pad
Base pad
Align the edge of the
base pad with the front edge
of the depressed section on the
paper tray #1.
Bank ASSY
For DX paper tray ASSY #1 *
(Front)
Paper tray ASSY #1
(DX paper tray ASSY #1*)
6-93
* For duplex print models
DX paper tray #1
Base pads
Align the edge of each base pad with
the front edge of the depressed
section on the DX paper tray #1.
Align the edge of each tray flap pad
with the rear edge of the depressed
section on the DX paper tray #1.
Tray flap pads
(6_79_1)
Confidential