Brother DCP6690CW Service Manual page 209

• After mounting the lower ADF chute on the document cover, be sure to route a bundle of
harnesses (document width sensor harness, document sensor PCB harness, and ADF motor
harness and its grounding wire) on the underside of the document cover and secure the bundle
with a cable tie as shown below.
After binding, cut off the excess of the cable tie with nippers.
Wires
Cut off the excess of the
cable tie with nippers.
ADF motor harness &
grounding wire
• When mounting the upper ADF chute on the document cover (see
provided on the bottom rear side into the slit in the document cover.
Document cover
ADF drive unit
Cable tie
Document width sensor harness
Document sensor PCB harness
6-28
Lower ADF chute
(6_29)
page 6-18), insert the latch
Confidential