Air Supply Connection - Pace ST 65 Operation & Maintenance Manual

Air Supply Connection

The ST 65 system utilizes an integral air venturi system to provide air pressure and
vacuum for any connected PACE SensaTemp air handpiece. Your in-house air supply
(regulated to 5.48 Bar (80 P.S.I.); see "Specifications") must be connected to the
system power source.
The system must be connected to a clean, dry, and filtered air supply regulated
to 5.48 Bar (80 P.S.I.); see "Specifications". Connection to a contaminated air
supply or one with pressure in excess of 6.16 Bar (90 p.s.i. may cause damage
to the power source.
1. Attach a length of Small, Flexible Air Hose (not supplied) to the Air Hose
Fitting on the rear of the PACE power source using the following procedure.
PACE does not recommend the attachment of quick connect air hose
fittings to the power source. The weight of the standard large air hose
lines will affect the stability of the system and would require a larger
bench space.
a) 230 VAC Systems only: A metric adapter fitting (PACE part number
1259-0081) is included for use with 230 VAC systems.
DO NOT overtighten connections.
Damage to the system could occur if
excessive torque is applied to the Air
Hose Fitting, metric adapter or
Connector.
b) Install the Connector (with Small,
Flexible Air Hose) onto the Air
Hose Fitting (or metric adapter)
finger tight. Using an
appropriate wrench, tighten the
Connector an additional 1/4 turn.
DO NOT overtighten.
2. Connect the free end of the small, flexible air line hose to your air supply
using the appropriate fittings.
NOTE
CAUTION
Set-Up
13