General Information; Introduction; Specifications - Pace ST 65 Operation & Maintenance Manual

General Information

Introduction

Thank you for purchasing the PACE model ST 65 Soldering/Desoldering System. This
manual will provide you with the information necessary to properly set up, operate and
maintain the system. Please read this manual thoroughly before using the system.
The ST 65 systems are available in either the 115 VAC, or 230 VAC version which
incorporates a highly responsive SensaTemp (closed loop) control system providing
up to 80 Watts of total power to a single output channel. The 230 VAC version
system bears the CE Conformity Marking which assures the user that it conforms
to all the requirements of council directive EMC 89/336/EEC. The systems
package the power source with a selection of accessories and functional aids.

Specifications

System Power Source Power Requirements
ST 65 - Operates on 97-127 VAC, 50/60Hz, 90 Watts maximum
at 115 VAC, 60Hz
ST 65E - Operates on 197-253 VAC 50/60Hz, 80 Watts maximum
at 230 VAC, 50Hz
Shop Air Input Requirements:
Pressure -
Air Flow -
Temperature Specifications
Handpieces
Tip Temperature Range: 204 to 454°C (400 to 850°F) nominal.
Temperature Stability: ±1.1°C (±2°F) at idle from set tip temp.
NOTE - Actual minimum and maximum Operating Tip Temperatures may vary
depending on Handpiece, Tip Selection and application.
EOS/ESD Specifications
The specifications shown below apply except on "Soft Ground Systems" which have
a 1 meg ohm current limiting resistance and a label placed on the power source front
panel referring to EN 100015-1.
Tip-To-Ground Resistance: Less than 2 ohms.
AC Leakage: Less than 2 millivolts RMS from 50Hz to 100MHz.
Transient Level: Less than 500 mV peak, out to 100MHz.
2
5.48 Bar (80 p.s.i.) recommended
6.17 Bar (90 p.s.i.) maximum
45.3 SLPM (1.6 SCFM) minimum