Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual page 80

SDP-Eco1630 III USERS MANUAL
•
Removing Plate jam 3
- Plate jam3 is displayed when the plate is not discharged.
Cover for the plate
removal port
Plate removal port
1) Press the
buzzer and returns the cutter to its
home position.
2) Open the front door and remove
the cutter cover.
3) Remove the plate in the transfer
section.
4) If the plate is not in the transfer
section, remove the processor
rack.
5) If the processor rack cannot be
removed, cut the visible plate
using a cutting bar.
Caution
6) Remove the processor rack and
then the plate.
7) With the processor rack removed,
Cutting bar
close the front door and run the
processor. Remove the plate
discharged from the roller after the
processor stops running.
8) Re-set the processor rack.
- 72 -
key. This stops the
Do not use the cutting bar
except to cut and remove
jammed plates. After
using the cutting bar,
store it in the designated
location with its cap on.