Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual page 40

SDP-Eco1630 III USERS MANUAL
•
Processing chemical replacement
Replace the processing chemical every three months regardless of the number
of plates processed.
•
Preparing rinse water
1) Pour approximately 1 liter of water into the rinse water replenisher bottle
and set it in the washing tank.
2) Always make sure that the bottle is filled with water before turning ON
the power switch.
3) After turning ON the power, reset the counter in the <Rinse> menu with
the following operation.
[Procedure]
(1) Push the
(2) Select
(3) Using the
menu.
(4) Push the
If the washing tank becomes empty of water, this will adversely affect the
Caution
plate's image quality. Replenish the rinse water everyday before starting
operation.
Replace the water in the washing tank every month. Replacement
frequency may vary depending on the quality of the water and the
season.
•
Confirming the remaining amount of rinse water and replenishment
When the rinse water is running out and needs to be replenished, the "Rinse
Tank Check" message appears in the display, causing the buzzer to sound.
Confirm the remaining amount of rinse water and replenish it as necessary.
1) Press the
2) Open the front door.
3) Remove the rinse water replenishing bottle and replenish it with rinse
water.
4) Return the rinse water replenishing bottle to its original position, and then
close the front door.
Note - Pressing the
reset the software counter, causing the message to appear in the display and
the buzzer to sound a while after the key has been pressed. To reset the
counter, open the front door, and then confirm the remaining amount of rinse
water, or display the
counter clearance operation. (For detailed operation, refer to the section
"Preparing Rinse Water.")
key to display
MENU
using the
<Rinse>
key, align the cursor to "CLR" in the
NT.
key to reset the counter.
key to turn the buzzer OFF.
key to delete the above message in the display does not
<Rinse>
- 32 -
.
< Plate Data >
key, and then push the
window in the users menu, and then perform a
NT.
key.
Count 150 CLR