Table of Contents
Advertisement
Resetting the punch counter
•
1) Pressing the
panel.
2) Press the
3) Press the
4) When
display and then select CLR.
5) Press the
7.5 Cleaning the processor section
After repeated prepress operations, silver residue from plates, paper dust,
chemicals, etc. may stick to the tank and/or processor rack, and stain
subsequent separations.
Note
- Always clean the sections shown below when you replace the processing
- Always follow the procedures in "4.9 Turning OFF the power supply and
Caution
You must thoroughly read "1.3 Handling processing chemicals".
Replenisher
bottle
SLM-EST
waste
SLM-EAC
chemical
waste
hose
chemical
hose
key bring up the
MENU
key to select the
NT.
key when
is displayed, press the
<MODE>
NT.
key resets the punch counter.
chemical every three months.
inspection at shutdown" on page 34 before shutting down the machine.
Maintenance
mat
Waste chemical tank
< Plate Data >
and then Press the
<MODE>
is displayed.
PUNCH DRYER >
key to bring up the
Cleaning the processor rack
•
1) Turn OFF the main power switch.
2) Lay out the maintenance mat.
3) Open the front door and remove
the replenisher bottle.
4) Discard the SLM-EAC and
SLM-EST into the waste chemi-
cal tank.
5) Hold the handle for the processor
rack section and pull out the
processor rack until it touches the
stopper.
- 51 -
Chapter 7 Maintenance
window on the display
NT.
key.
< COUNT••••CLR
Hide quick links:
Advertisement
Table of Contents
