Exposure - Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual

4.6 Exposure

The machine has two exposure modes: remote exposure which performs
exposure using data provided from the host computer, and local exposure
which performs laser test exposure and re-exposure.
•
Remote exposure
After entering remote mode (ON LINE lamp is lit), give the exposure
command through the host computer (RIP computer). While exposure is in
progress, "Exposing ***%" is displayed on the panel display. "***%"
indicates the percentage currently exposed.
[Display during remote exposure]
The panel display changes as shown below during the exposure.
•
Local exposure
[Laser Test Expo.]
(1) Confirmation and input of the plate type, resolution and light intensity
1) Use the
2) Select
3) Press the
4) Plate type, resolution and light intensity are displayed.
5) Press the
6) Press the
7) Change the light intensity value using the
Note
Press the
setting is discontinued.
Data transmission start
Data transmission end
Image data exposure start
Image data exposure end
Plate is being discharged
Completion
key to call up
MENU
<Laser> using the
NT.
key while
(Example)
F 1 7 5 ( 1 2 )
NT.
key to change the resolution. Select the desired
resolution from among 12 (1200 dpi), 15 (1500 dpi), 18 (1800 dpi)
and 24(2400dpi) using the
NT.
the key.
key to move the cursor to the light intensity value
display and then press the
NT.
Press the key to register the light intensity value.
key to return to the previous menu if no change is necessary or
MENU
Data Transferring
Exposing
Exposing
Discharging
Complete
display.
< Plate Data >
key and press the
Laser Test Expo.
(F175 1200 dpi Light intensity 200)
2 0 0
key. Register the resolution using
NT.
key.
- 29 -
Chapter 4 Operation
0%
100%
NT.
key.
is displayed.
key or the key.