Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual page 48

SDP-Eco1630 III USERS MANUAL
•
Switch the mode between remote and local
Remote Mode
Start OK
•
Shift between commands (Example)
1st hierarchy
2nd hierarchy
•
Command execution
There are two types of commands: one which activates machine functions
such as preliminary feeding and cutter-processor commands, and one which is
used, for example, to set numerical values.
For commands in which numerical values can be changed (Example:
Referring to P27 "4.4 Data input for the set plate")
Use the
NT.
some modes the numerical value display starts flashing from the time it is first
displayed.)
The
Press the
If you wish to reset a value or interrupt the setting procedure, press the
key to return to the upper menu level without changing the currently set value
and re-start the setting procedure from the beginning by selecting the same
command.
For commands in which numerical values can not be changed (Example:
Referring to P28 "4.5 Execution of Pre. Feed command")
Use the
execute it.
Repeatedly press the
line mode.
ENU
<
Maintenance>
ENU
NT.
Cutter Processor>
to move the cursor to the numerical value display. Press the
key to start the display flashing and change the displayed value. (In
or key increases/decreases a numerical value.
NT.
key when the desired number appears.
to select the desired command. Then press the
ENU
key until Start OK is displayed to return to the on-
Local Mode
<
Plate Data>
<
Ver SCSI-ID>
- 40 -
ENU
NT.
key to