List Of Error Messages - Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual

8.5 List of error messages

The following is a list of error messages, and steps that can be taken.
Serial error
JAM1
JAM2
JAM3
I/F error1
ME1
ME2
ME3 Nip free
ME4
ME5
ME6
ME7
ME8
Message
An internal communication error occurred. Re-boot the
machine.
If this error occurs frequently, please contact the dealer
where you purchased this machine.
The plate is jammed. Remove the plate following the
jam removal procedure.
The plate is jammed. Remove the plate following the
jam removal procedure.
The plate is jammed. Remove the plate following the
jam removal procedure.
A SCSI communication error occurred. Re-boot the
machine. If this error occurs frequently, please contact
the dealer where you purchased this machine.
The cutter does not return to its initial position. Turn ON
the power switch again.
The cutter is not located at its initial position. Turn ON
the power switch again.
The nip roller is open. Close the nip roller clearance
handle.
An internal communication error occurred in the
machine. If this error occurs frequently, please contact
the dealer where you purchased this machine.
An internal communication error occurred. Re-boot the
machine.
If this error occurs frequently, please contact the dealer
where you purchased this machine.
The laser does not light. It may be caused by low laser,
but if it occurs even after you boost the laser, please
contact the dealer where you purchased this machine.
A problem occurred in the polygon mirror. Please
contact the dealer where you purchased this machine.
A problem occurred in the processor heater. Please
contact the dealer where you purchased this machine.
Error contents
- 69 -
Chapter 8 Message