Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual page 28

SDP-Eco1630 III USERS MANUAL
Make sure that the lateral edges
of the plate are still even after
the roll is set on the spool shaft.
Plate
Spool plate (reference side)
Spool plate
(contact side)
Set screw
(contact side)
Must be located
o
exactly (180 )
opposite the one
on the reference
side.
4) Lower a roll of plate (wound in
the same direction as in the figure
on the left) down over the spool
shaft. (The shaft should be
standing vertically with the
reference side of the spool plate as
its base.).
Firmly press the edge of the plate
roll against the spool plate
(reference side) until they touch
equally all around the periphery of
the roll.
5) Firmly snap the contact side of the
spool plate down over the spool
shaft and continue pressing the
plate (contact side) downward to
the edge of the plate roll until
there are no intervening gaps.
Plate
Position the contact side of the
spool plate so that its set screw is
positioned 180
on the reference side.
Note
Set screw
(reference
side)
- 20 -
No gaps here.
opposite the one
o
The two set screws are
fixed 180 opposite each
o
other to prevent rotational
imbalance due to the
weight of the screws.