Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual page 54

SDP-Eco1630 III USERS MANUAL
• The alarm function in this machine has been set to OFF before shipment at
• The consumption rate of rinse water may be different depending on the
[Procedure] (In cases where the current values are changed to "150".)
(1) Push the
(2) Select
(3) When
under the setting, and then push the
(4) Push either the
settings to "150".
(5) After changing the setting, push the
(6) Push the
Note
Use "120 to 160" as a reference value. Adjust the rate of rinse water reduction
depending on the installation conditions of the machine.
(Adjustable range: 50 to 300. Note that using "000" deactivates this function.)
[Notes for adjustment]
(1) When the "Rinse Tank Check" message is displayed.
If the replenishing bottle is empty, decrease the setting.
If there is a lot of rinse water left in the bottle, increase the setting.
(2) To deactivate the software counter function, use "000" as a setting value.
Be sure to reset the counter by "CLR" after you have adjusted the setting.
the factory.
(Settings 000 = OFF)
settings in the machine. Set the consumption rate with the following
procedure.
key to display the
MENU
with the
< Rinse >
is displayed, make sure that the cursor is placed
Count 150 CLR
key (Increase) or the
key two times to display the
MENU
window.
< Plate Data >
key, and then push the
NT.
key.
NT.
key to confirm the setting.
< Plate Data >
- 46 -
NT.
key.
key (Decrease) to set the
window.