Laser Menu - Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual

SDP-Eco1630 III USERS MANUAL
•
Remaining amount of plate
The remaining amount of plate should be set in meter units when you use a
new plate.
The initial setting value is 0 meter.
The remaining amount of plate is shown in 1 meter increments (0 to 75
meters) in the remote mode display
The remaining amount value is calculated by subtracting the exposed plate
length from the plate length set by the operator. The plate length for
preliminary feeding is also subtracted.
However, the accuracy of the remaining length measurement is not
guaranteed. Please regard this value simply as a reference guide.

6.2 Laser menu

The laser menu contains a command to set the laser for exposing the current
plate.
•
Resolution setting
(12) ......1200dpi
(15) ......1500dpi
(18) ......1800dpi
(24) ......2400dpi
•
Laser setting
From the panel, you can set the exposure laser for each resolution to be used
with the current plate.
1) Set the resolution and laser value.
2) If necessary, expose a trial sheet to adjust the laser.
Sample panel display
Plate type
Resolution Laser value
F 1 7 5 ( 1 2 )
- 42 -
2 0 0