Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual page 46

SDP-Eco1630 III USERS MANUAL
•
Operation status
[Remote and local]
In the remote mode, it is possible to expose data transferred from the host
computer (RIP computer). In the local mode, exposure data from the host
computer (RIP computer) cannot be accepted.
The local mode includes a "User menu" (including user maintenance
functions) and a "Maintenance menu".
[User menu]
The "User menu" provides the basic commands necessary to operate the
machine.
[Maintenance menu]
If a command or a dialog for a command that is not included in the User
menu list appears, immediately press the
to the User menu. (Do NOT press the
This menu is used to adjust the SDP-Eco 1630 III.
[Standby mode]
In remote mode, if no command is sent to the machine for 10 minutes, it
enters the standby mode.
The standby mode will be canceled whenever a command is given or
when any key on the panel except the
Note Recovery time will differ depending on whether the machine has been in standby
mode for more than 10 minutes. If the machine was left idle for more than 10
minutes, recovery will take longer because a cleaning routine is performed for
the processor roller.
[Auto power OFF]
When this machine is left in the local mode for two hours, a cleaning
routine is performed for the processor roller and the power is turned OFF
automatically.
ENU
NT.
key.)
key is pressed.
- 38 -
key several times to return