Table of Contents
Advertisement
5.2 Panel operation
•
Power ON/OFF key
Press this key to turn OFF the power supply to the machine and shut it
down (after cleaning the processor roller). To re-start the machine, press
the Power ON/OFF key again.
This key only works in the first local status display and does not work at
all in the remote status.
[Final inspection display]
Waste Tank?
Final inspection
Caution
Always press the Power ON/OFF key when the operation ends.
•
Remote mode display
The following display appears on the panel while the remote mode is selected.
START OK
The ON LINE lamp is lit while this is displayed.
Pressing the
Pressing the
hard disk drive.
•
Menu/command selection
Use the
commands. The
modes. The
The
commands appear with one of their letters underlined. You can select
commands on the right by pressing the right key and commands on the left
with the left key.
Pressing the
display shows the next (hidden) menu to the right. (Simply reverse this step
to move to hidden menus on the left.) When you find the desired menu, press
NT.
the
Nip Free
key shows the current state of the plate.
key shows the number of images in data remaining on the
Amount of image data which has not yet been exposed.
HDD
1/2
Amount of image data in the hard disk drive.
ENU
key,
ENU
key brings up the menu level in the remote and local
keys switch the menu level between remote and local.
keys are used to shift between commands. Selectable
key when a ">" mark is shown at the right edge of the menu
key. Proceed to the next menu.
Chapter 5 Menus and panel displays
Cleaning
NT.
keys, and
- 39 -
Power OFF
key to select menus or
Hide quick links:
Advertisement
Table of Contents
