Processor Section - Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual

4.7 Processor section

The processing chemicals are applied to the plate while it is being transferred
in the SDP-Eco 1630 III's built-in processor section. The processor section
also includes a final rinsing process which cleans the developed plates and
thus reduces paper media waste (from processing chemical stains) at the start
of printing.
Rinse water
replenisher
bottle
Washing tank
Waste
water hose
SLM-EST
drainage
hose
SLM-EST
replenisher
bottle
SLM-EST
processing
chemical tank
You must thoroughly read "1.3 Handling processing chemicals".
Caution
•
Preparing and pouring processing chemical
1) Fasten a replenishment cap on the replenisher bottle which contains the
processing chemical and set it in the tank.
Be sure to set the bottle in the appropriate tank since the SLM-EAC
Caution
and SLM-EST cause different (opposing) effects.
•
Processing chemical replenishment
As the processing chemical decreases, the liquid level in the tank goes down
and finally the "Empty EST" or "Empty EAC" message appears on the display
(accompanied by a buzzer sound). Replenish the processing chemical
following the procedure below.
Replenish the processing chemical and replace the processing bottle
following the procedure below.
1) Press the
2) Open the front door.
3) Add processing chemical from the container (10 liters) to the replenisher
bottle.
4) Put the cap back on the replenisher bottle and set it in the tank.
Processor rack
SLM-EAC
replenisher
SLM-EAC
bottle
drainage
SLM-EAC
hose
processing
chemical tank
key to turn off the buzzer.
- 31 -
Chapter 4 Operation
Waste chemical tank
Waste chemical vat
Cap