Table of Contents
Advertisement
4.4 Data input for the set plate (This procedure is necessary when
loading the plate.)
(1) Press the
(2) Press the
level of the
(3) Use the
width, or length of plate roll, then press the
(indicating mode change).
(4) Press the
Note
• Input the plate data and press the
up the
the
(Example)
1) Selection of Data Memory Channel (From M0 to M3)
M 0 F 1 7 5 4 1 4 6 1 m
Cursor
M 3 F 1 0 0 4 0 4 3 7 m
2) Selection of plate type (From F100 to F175)
M3 F100 404 37m
M3 F175 404 61m
3) Selection of the plate width (From 404 to 414)
M3 F175 404 61m
M3 F175 414 61m
key to display the
MENU
NT.
key to display
menu.
< Plate Data >
key to select the data registration number, plate type, plate
NT.
key after changing the data using the
display and press the key once more to call up
< Plate Data >
display and switch to the on-line mode.
Start OK
- 27 -
.
< Plate Data >
M0
R 1 7 5
414
key. Press the
NT.
Press the
cursor key flashing and select M0 to
M9 using the
If setting
key. Press the
M3
data channel.
Press the
move the cursor to the F100 display
(plate type). Press the
start the cursor flashing. Select the
plate type (F175, R175) using the
key or the
NT.
the
key to register the plate type.
Press the
move the cursor to the 404 display
(plate width). Press the
start the cursor flashing. Select the
plate width using the
key and press the
register the plate width.
Chapter 4 Operation
, which is a lower
00m
NT.
key to flash the cursor
or
key.
key once to call
MENU
NT.
key in order to start the
key or the
NT.
key to register the
key or the
key to
NT.
key to
key and press
key or the
key to
NT.
key to
key or the
NT.
key to
Hide quick links:
Advertisement
Table of Contents
