Plate End Processing - Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual

3.2 Plate end processing

When plate end is displayed, remove the plate and re-set a new one following
the procedure below.
1) When
The plate ended during exposure, so it is discharged from the processor.
Stop the buzzer by pressing the
After the plate is discharged, press the
and mount a new plate following the procedure mentioned in "3.1 Plate
setting".
Cover for the plate
removal port
Plate removal port
<Plate End>
is displayed on the panel:
- 23 -
Chapter 3 Handling Plates
(reset) key.
key to shift to the local mode,
MENU
Whether or not data will be
Note
exposed depends on the
amount of exposure data
remaining when the plate end
is detected.
2) When
Pick up plate
on the panel:
Plate ended at the beginning of an
exposure, so the remainder is
shorter than the processor's
minimum transfer length. Please
remove the plate.
1. Open the front door and remove
the plate through the plate removal
port.
2. Close the door and press the
key to return to the local mode.
3. Re-set the plate following the
procedure mentioned in "3.1 Plate
setting".
is displayed