Chapter 3 Handling Plates; Plate Setting - Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual

Chapter 3 Handling plates

3.1 Plate setting

305 (12)
310 (12 1/5)
324 (12 3/4)
335 (13 3/16)
340 (13 3/8)
370 (14 9/16)
Red tape
Marker
Edge of boss
Lever
Plate setting cover
Spool shaft
229 (9)
254 (10)
400 (15 3/4)
279 (11)
404 (15 7/8)
414 (16 3/10)
Spool plate
Set screw
1) Open the plate setting cover and,
holding the lever with your thumb,
take the spool shaft out.
2) Refer to your plate width, and
align the edge of the spool plate
boss to the groove in the spool
shaft. The spool shaft grooves are
numbered from outer side in the
following order: 414, 404, 400,
370, 340, 335, 324, 310, 305, 279,
254, and 229.
Caution
3) To prevent the reference side of
the spool plate from shifting from
its designated position, insert a
screw driver into the set screw
hole and firmly fix the set screw to
the spool shaft.
Always fix the set screw on the
flat side of the spool shaft.
- 19 -
Chapter 3 Handling Plates
Red tape is affixed to the
reference side of the
spool shaft.