List Of Expendable Parts; How To Order Parts - Mitsubishi SILVER DIGIPLATER SDP-ECO 1630 III User Manual

7.8 List of expendable parts

Parts name
NT cutter blade
Pump unit (EAC)
Pump unit (EST)
Note
After 25000 prepress processes, a "Pump Check" message appears on the
-
display panel when the power switch is turned ON.
This indicates that it is time to replace the pump, so please contact the
serviceman and request a pump replacement.
Always replace the pump units for EAC and EST at the same time.
Clear this panel display by pressing the RESET key and continue the initial
inspection.
Average lifetime varies depending on the usage condition (input voltage,
-
ambient environment, temperature, humidity, and daily maintenance).
When expendable parts noted in the list must be replaced, customers will be
-
charged for labor and parts costs even if the equipment is still within its
warrantee period.

7.9 How to order parts

The SDP-Eco 1630 III has many parts, some of which users can replace on
their own and some which require service personnel to replace. If you wish
to order any parts, please do the following:
(1) Indicate whether you just need the parts, or whether you need to have
them replaced by service personnel.
(2) Information from your warranty or machine name plate
i) Model: SDP-Eco 1630 III
ii) Serial number
(3) Names and numbers of necessary parts, quantities, date required
- Please be aware that new models may be developed and specifications
Caution
may change without notice, so parts may differ from those listed in this
operation manual.
- Mitsubishi Paper Mills Ltd. takes no responsibility for improvements
users may undertake on their own or in collaboration with another
company.
Parts code
200400107
1 set (contains 10 blades)
U1105011
U1105012
- 65 -
Chapter 7 Maintenance
Unit When to replace
After cutting
two plate rolls.
After completing 25000
1 set
prepress processes.
After completing 25000
1 set
prepress processes.