Rotax 912 Series Maintenance Manual page 129

Step
3
4
5
6
7
8
Graphic
Replacing the coolant
Fig. 12
Effectivity: 912 Series
Edition 3 / Rev. 1
BRP-Powertrain
MAINTENANCE MANUAL
Drain the engine coolant.
NOTES: If the radiator is located below the engine, also detach the
lowest positioned coolant hose.
Fit attachment screw (stainless steel) along with a new sealing ring. Tighten to
10 Nm (90 in.lb).
If the coolant is being replaced with a different type, (conventional coolant, wa-
terless coolant) the cooling system must be flushed. See chap. 12-20-00 sec-
tion: 9.3).
Refill newly mixed coolant into the expansion tank (highest point of the cooling
system). See chap. 12-10-00 section: 3.1).
Fit radiator cap.
NOTES: Run the engine briefly and replenish with clean coolant as
required.
Part
1 Attachment screw (stainless steel)
2 Water pump
Procedure
1
2
Function
12-20-00
08533
page 25
January 01/2013