Gearbox - Volkswagen Golf Variant 2007 Workshop Manual

The catalogue is also available on ⇒ CD-ROM and can be ordered
the usual way from Bertelsmann.
Uncertainty often occurs with smaller bolts having low tightening
forces. Torque wrench 2...10 Nm -V.A.G 1783- can be used with
these bolts.
1.10

Gearbox

♦ If gearbox covers have been unbolted or gearbox has no fluid,
do not run engine or tow vehicle.
♦ First thoroughly clean connecting points and surrounding
areas and then loosen bolts.
♦ When installing the gearbox, ensure that dowel sleeves be‐
tween the engine and gearbox are correctly located.
♦ Place removed parts on a clean surface. Cover parts to pre‐
vent soiling. Use plastic sheeting and paper. Use lint-free
cloths only!
♦ Install only clean parts; do not remove new parts from pack‐
aging until immediately before installing.
♦ If repair work cannot be performed immediately, carefully cov‐
er or seal components.
♦ With gearbox removed, secure torque converter against falling
out.
Gearboxes with and without filler pipe
Here is an "example" with a filler pipe as it is installed in "older"
gearboxes. This pipe has been discontinued.
This "old" filler opening with the red cap is not needed because
ATF can be drained or filled as required through the bottom hole.
The "height" of this tube determines the level of the ATF.
The tube must be removed to drain the fluid.
♦ After installation, check the ATF level and top up
⇒ page 77 .
♦ Capacities ⇒ page 7
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
.
6-speed automatic gearbox 09G - Edition 04.2010
1. Suggestions and criticism, general repair notes
3