Volkswagen Golf Variant 2007 Workshop Manual page 45

– In order to remove selector lever cable from gearbox, first re‐
lease cable -arrows 1- and then remove it from cable support
bracket -arrow 2-.
Note
Do not use any pliers, otherwise securing tabs on cable sup‐
♦
port bracket could break off.
Do not bend or kink selector lever cable.
♦
– Lever cable -1- off lever -3- using an open jaw spanner -2-.
– Tighten hose clamps up to Ø 25 mm -3094- on hoses and
remove hoses from ATF cooler.
– Disconnect electrical connections to gearbox and starter.
– Remove upper starter motor bolt.
– Set up support bracket -10 - 222 A- and support engine with
gearbox. Do not raise.
– Remove upper engine/gearbox connecting bolts.
Bolts may be installed with a socket -T10179- . However, note
lower torque setting when tightening
6. Removing and installing gearbox, Jetta 2005 ▸, Bora 2006 ▸, Golf Variant 2007 ▸, Jetta Wagon 2008 ▸
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed automatic gearbox 09G - Edition 04.2010
⇒ page 54 .
41