Checking Selector Lever Cable; Adjusting Selector Lever Cable - Volkswagen Golf Variant 2007 Workshop Manual

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed automatic gearbox 09G - Edition 04.2010
4.4

Checking selector lever cable

Brief description
To check ease of movement of selector lever cable, it must be
removed from the gearbox and the free end must be placed so
that it does not bump against anything.
Then move selector lever and reinstall the selector lever cable.
Then the selector lever cable must be adjusted
Do not grease connection of selector lever cable.
Carry out procedure as follows:
– Move selector lever to position "P" position.
– Loosen bolt -2- of selector lever cable -1-.
– Lever cable -1- from selector shaft lever -3- using an open jaw
spanner -2-.
– Cable is removed from cable support bracket by pressing
catches together -arrows-.
– Move selector lever repeatedly from "P" to "S" and back to "P".
• Selector lever must move easily.
– Install selector lever cable again.
– Adjust selector lever cable!
4.5

Adjusting selector lever cable

Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1331-
The selector lever cable must always be adjusted whenever
♦ The selector lever cable has been removed from the gearbox.
♦ The engine and/or gearbox has been removed and installed.
30
Rep. Gr.37 - Controls, housing
⇒ page 30 .