Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed automatic gearbox 09G - Edition 04.2010
5.2
Removing and installing selector lever
and selector mechanism with selector
lever cable from 03.2009 onwards
Note
Selector mechanism and selector lever cable are not allowed
♦
to be separated from one another. Both are removed together.
Following installation, selector lever cable must be checked
♦
for ease of movement and be adjusted.
Carry out procedure as follows:
– Move selector lever to position "P" position.
– Remove selector lever handle
– Remove centre console ⇒ Rep. Gr. 68 ; Compartments, cov‐
ers and trims .
– Pull connector off selector mechanism.
– Remove 4 bolts.
Torque setting 8 Nm.
– In order to remove selector lever cable from gearbox, first re‐
lease cable -arrows 1- and then remove it from cable support
bracket -arrow 2-.
Note
Do not use any pliers, otherwise securing tabs on cable sup‐
♦
port bracket could break off.
Do not bend or kink selector lever cable.
♦
– Lever cable -1- off lever -3- using an open jaw spanner -2-.
– Raise vehicle.
– Remove exhaust system below heat shield ⇒ Rep. Gr. 26 ;
Removing and installing parts of exhaust system .
– Remove heat shield beneath selector mechanism.
36
Rep. Gr.37 - Controls, housing
⇒ page 32
.