Checking Selector Lever Cable; Adjusting Selector Lever Cable - Volkswagen Golf Variant 2007 Workshop Manual

– Remove selector mechanism.
Install in reverse order of removal.
– Before you put on ball head: check cable
– Install all parts of exhaust system which were removed ⇒ Rep.
Gr. 26 ; Removing and installing parts of exhaust system .
– Install heat shield ⇒ Rep. Gr. 66 .
– Adjust selector lever cable after installing
2.5

Checking selector lever cable

Brief description
Selector lever cable must be removed from gearbox so that its
freedom of movement can be checked. Put removed end down
so it does not rub against anything.
Then the selector lever must be moved and after that, the Bowden
cable must be reattached to the gearbox.
Then the selector lever cable must be adjusted
Do not grease connections of cable!
Checking
– Move selector lever to position "P" position.
– Remove cable from lever on gearbox.
– Move selector lever repeatedly from "P" to "S" and back to "P".
• Selector lever must move easily.
– Reinstall cable with "loosened" adjustment screw.
If you remove the securing clip, you must always install a "new"
securing clip.
– Adjust cable ⇒ page 43
2.6

Adjusting selector lever cable

Special tools and workshop equipment required
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
7-speed dual clutch gearbox 0AM - Edition 07.2010
⇒ page 43
⇒ page 43
⇒ page 43
.
.
.
.
43
2. Selector mechanism