Ricoh D117 Service Manual page 1000

Printer Service Mode
1001 Bit Switch
bit 4
DFU
to 7
1001 Bit Switch
009 Bit Switch 9
bit 0 PDL Auto Detection timeout of jobs
submitted via USB or Parallel Port (IEEE
1284).
To be used if PDL auto-detection fails. A failure of PDL autodetection does
not necessarily mean that the job can not be printed. This bit switch tells the
device whether to time-out immediately (default) upon failure or to wait 10
seconds.
bit 1 DFU
bit 2 Job Cancel
Enable: All jobs will be cancelled after a jam occurs.
Note: If this bit switch is enabled, printing under the following conditions
might result in problems:
- Job submission via USB or parallel port
- Spool printing (WIM > Configuration > Device Settings > System)
bit 3 DFU
bit 4 Timing of the PJL Status ReadBack (JOB
END) when printing multiple collated
copies.
D117/D118
0: Disable
(Immediately)
0: Disable
cancelld)
0: Disable
3-498
- -
0 1
1: Enable
(10 seconds)
- -
1: Enabled
(Not
(Cancelled)
- -
1: Enable
SM Appendix