Receiver Installation- Glow Engine Option - Hangar 9 Alpha 40 ARF Assembly Manual

Receiver Installation-
glow Engine option
Required Parts
Fuselage Radio tray
#4 x 5/8-inch wood screw Receiver battery
Switch harness Receiver
1/4-inch (6mm) foam (not included)
Required Tools and Adhesives
Phillips screwdriver: #1 Hook and loop tape
Drill bit: 3/32-inch (2.5mm) Drill
Pencil Thin CA
Hobby knife with #11 blade Scissors

Step 1
Locate the hardware necessary to install the radio tray
in the fuselage.
22

Step 2
Slide the radio tray into the notches in the former. The tray will
fit against the rear of the fuel tank to keep it from moving.

Step 3
Use a pencil to mark the support block in the fuselage for the
radio tray screw.

Step 4
Remove the radio tray from the fuselage. Use a drill and
3/32-inch (2.5mm) drill bit to drill a hole in the support block
for the screw that will secure the position of the radio tray.
Hangar 9 Alpha 40 ARF Assembly Manual