Hangar 9 Alpha 40 ARF Assembly Manual page 36


Step 12
Remove the rudder servo horn. Use pliers to bend the pushrod
wire 90-degrees at the mark made in the previous step.

Step 13
Slide the pushrod wire through the hole in the servo horn.
The horn will fit against the bend in the wire.
36

Step 14
Slide the pushrod snap link on the wire. Rotate the link so it
snaps on the wire. You may need to use pliers to snap the
link onto the wire.

Step 15
Use diagonal cutters to trim the excess wire above the
link so it does not interfere with the operation of the radio
system. Leave a small amount of wire so the pushrod snap
link cannot accidentally slip up and over the wire.

Step 16
Slide the steering pushrod wire through the pushrod
connector. Use the screw from the servo and a #1 Phillips
screwdriver to attach the horn to the rudder servo.
Hangar 9 Alpha 40 ARF Assembly Manual