Receiver Installation - Electric Motor Option - Hangar 9 Alpha 40 ARF Assembly Manual


Step 14
Fit the gear to the fuselage. They must fit flush with the
bottom of the fuselage as shown. If not, it may be necessary
to enlarge the bevel made back in Step 9.

Step 15
Secure the main landing gear assemblies using the two
landing gear straps and four #4 x 3/8-inch wood screws. Use
a #2 Phillips screwdriver to tighten the screws.
Hangar 9 Alpha 40 ARF Assembly Manual
Receiver Installation-
Electric Motor option
Required Parts
Fuselage Receiver
Required Tools and Adhesives
Hook and loop tape

Step 1
Plug the rudder, elevator and throttle servos into the appropriate
ports of the receiver. The 6-inch (152mm) extension should still
be plugged in the aileron port of the receiver.

Step 2
Mount the receiver to the bottom of the fuselage using hook
and loop tape.

Step 3
The remote receiver is then mounted to the side of the
fuselage above the elevator servo using hook and loop tape.
Mount it as high as possible in the fuselage for the best
reception from your radio system.
21