Hangar 9 Alpha 40 ARF Assembly Manual page 35


Step 8
Use a hobby knife to cut a 1/4-inch (6mm) piece from the clear
safety tubing. Slide the tubing onto the clevis, and then thread
the clevis 10-turns on the rudder pushrod wire as shown.
Hangar 9 Alpha 40 ARF Assembly Manual

Step 9
Connect the clevis to the center hole of the rudder control
horn. Slide the safety tubing over the forks of the clevis to
prevent it from opening accidentally.

Step 10
Place the servo horn back on the rudder servo. Make sure
the horn is aligned correctly as described previously.

Step 11
Use a ruler to make sure the rudder is centered with the
fin. Use a felt-tipped pen to mark the pushrod wire where it
crosses the hole enlarged previously on the servo horn.
Attach clevis
to center hole
35