Wing Installation - Hangar 9 Alpha 40 ARF Assembly Manual


Step 9
Connect the clevises from the aileron pushrods to the aileron
control horns. The alignment of the ailerons will be checked
later in this manual.

Step 10
Plug the aileron servo into the extension coming from the
aileron port of the receiver. Turn on the radio system and
center the aileron stick and trim. Use a ruler to check that the
aileron are in alignment with the bottom of the wing. If they
are not, thread the clevis in or out as necessary to align the
aileron and wing. Make sure to align both aileron at this time.
Hangar 9 Alpha 40 ARF Assembly Manual

Wing Installation

Required Parts
Wing Fuselage
Rubber band (10)

Step 1
Locate the rubber band to secure the wing to the fuselage.

Step 2
Locate the aileron extension that is inside the fuselage. Align
the colors from the aileron servo lead with the extension so
they match, then plug them together.

Step 3
Start securing the wing to the fuselage by installing two of
the rubber bands.
hint: Always start with the cross rubber bands. This
will keep the wing from twisting on the fuselage when
installing the remaining rubber bands.

Step 4
Install a second set of rubber bands on the wing
as shown.
43