Receiver Installation-Electric Motor Option; Receiver Installation-Glow Engine Option - Hangar 9 Alpha 40 ARF Assembly Manual

Receiver Installation-
Electric Motor option
Required Parts
Fuselage Receiver
Required Tools and Adhesives
Hook and loop tape

Step 1
Plug the rudder, elevator and throttle servos into the appropriate
ports of the receiver. The 6-inch (152mm) extension should still
be plugged in the aileron port of the receiver.

Step 2
Mount the receiver to the bottom of the fuselage using hook
and loop tape.
Hangar 9 Alpha 40 ARF Assembly Manual

Step 3
The remote receiver is then mounted to the side of the
fuselage above the elevator servo using hook and loop tape.
Mount it as high as possible in the fuselage for the best
reception from your radio system.
Receiver Installation-
glow Engine option
Required Parts
Fuselage Radio tray
#4 x 5/8-inch wood screw Receiver battery
Switch harness Receiver
1/4-inch (6mm) foam (not included)
Required Tools and Adhesives
Phillips screwdriver: #1 Hook and loop tape
Drill bit: 3/32-inch (2.5mm) Drill
Pencil Thin CA
Hobby knife with #11 blade Scissors

Step 1
Locate the hardware necessary to install the radio tray
in the fuselage.
23