Fin And Stabilizer Installation - Hangar 9 Alpha 40 ARF Assembly Manual


Step 3
Slide the wing dowel into the pre-drilled holes in the front
of the fuselage. Center the dowel so it extends equally from
both sides of the fuselage.
Hangar 9 Alpha 40 ARF Assembly Manual

Step 4
Slide the second wing dowel into the pre-drilled holes in the
rear of the fuselage. Center the dowel so it extends equally
from both sides of the fuselage.

Step 5
Apply thin CA into the joint between the dowel and fuselage
to keep it from moving.

Fin and Stabilizer Installation

Required Parts
Fin/Rudder assembly #4 washer (4)
Stabilizer/Elevator assembly Wing nut (2)
3mm x 10mm machine screw (2)
Required Tools and Adhesives
Phillips screwdriver: #1 Threadlock
Hobby knife with #11 blade

Step 1
Locate the fin and stabilizer assemblies and the hardware
necessary to install them on the fuselage.

Step 2
Use a hobby knife with a #11 blade to remove the covering
from the notch at the front of the stabilizer. Also remove the
covering from the pre-drilled holes in the stabilizer.
25