Aileron Servo Installation - Hangar 9 Alpha 40 ARF Assembly Manual


Step 17
Center the nosewheel so it is aligned with the centerline of
the fuselage. Use a 3mm x 3mm setscrew and 1.5mm hex
wrench to tighten the setscrew that secures the steering
pushrod wire. Make sure to use threadlock on the setscrew.
note: If you find that your model does not track straight
on the ground, loosen the setscrew to adjust the steering.
Do not use the rudder trim to adjust the steering. Use the
rudder trim for in-flight corrections only.

Step 18
If you are going to step away from your model, make sure to
turn off both the transmitter and receiver.
Hangar 9 Alpha 40 ARF Assembly Manual

Aileron Servo Installation

Required Parts
Wing panel, right Servo with hardware
Clevis (2) Pushrod snap link (2)
2-56 x 6 / -inch pushrod wire (2)
1
8
Safety tubing
Required Tools and Adhesives
Drill bit: 5/64-inch (2mm) Drill
Hobby knife with #11 blade Pin vise
Ruler Pliers
Pencil Thin CA
Phillips screwdriver: #1

Step 1
Locate the items necessary to install the aileron servo
in the wing.

Step 2
Install the grommets and brass eyelets in the servo. Place the
servo in the wing with the servo output shaft to the trailing
edge of the wing. Use a pencil to transfer the positions for the
servo mounting screws onto the servo mount.
37