Usa Conformance Standards - Extreme Networks ExtremeWireless AP3935i Installation Manual

• This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.

USA Conformance Standards

This equipment meets the following conformance standards:
Safety
• UL 60950‐1
EMC
• FCC CFR 47 Part 15, Class B
Radio transceiver
• CFR 47 Part 15.247, Subpart C
• CFR 47 Part 15.407, Subpart E
Other
• IEEE 802.11ac (5 GHz)
• IEEE 802.11b/g (2.4 GHz)
• IEEE 802.11n
• IEEE 802.3at (PoE)
• IEEE 802.3af (PoE)
26 ExtremeWireless AP3935i and AP3935e
Warning
The ExtremeWireless AP3935 must be installed and used in strict accordance
with the manufacturer's instructions as described in this guide and related
documentation for the device to which the ExtremeWireless AP3935 is
connected. Any other installation or use of the product violates FCC Part 15
regulations.
This Part 15 radio device operates on a non-interference basis with other
devices operating at the same frequency when using the antennas provided or
other Extreme Networks-certified antennas. Any changes or modifications to
the product not expressly approved by Extreme Networks could void the user's
authority to operate this device.
For the product available in the USA market, only channels 1 to 11 can be
operated. Selection of other channels in the 2.4 GHz band is not possible.